Post-Heating (#16)

It is important to achieve high initial adhesion in the fast turn-around sign fabrication market. This high adhesion helps to reduce the chance for bubbles, wrinkles and edge curl later on in the sign’s life.

Most computer and die cut graphic film for use in the sign making market is coated with pressure sensitive adhesive (PSA). This type of adhesive only needs to contact a compatible surface to work successfully but making complete contact can take more time than the sign maker has. Once initial application is made, the adhesive “cold flows” and approximately 72 hours later the adhesive has made contact with all the potential bonding sites. In sign making vernacular, terms such as cure time or set-up time are used to describe the period of time in which cold flow has achieved maximum contact. Although, there is no actual “curing,” the idea that graphic film needs time to attain ultimate bond remains valid.

The bond of vinyl can increase with three factors: Heat, pressure and time. Depending on environment conditions, the initial surface bond will be reached after approximately 1 to 2 weeks with 20°C and minor humidity level.

If a higher initial surface bond is needed quickly, the following are several recommendations:

• Apply additional high pressure passes with a hard squeegee for application to flat surfaces. 
• Use a finishing pass with a rivet brush on any textured surfaces, including banners and ribbed hollow plastic sheeting. 
• Warm the vinyl with a heat gun or torch during installation to help soften the adhesive and allow it to make contact faster.

Heat Gun

1. Heat up the vinyl up to 95-105°C using a heat gun
2. Push the film across the heated section with your finger
3. Air channels should become visible and sharp on the face side of the film. That proves that the air channels are collapsed and the adhesive bond is increased.
    

Nie znalazłeś tego, czego szukasz?

Wiele z tych wskazówek zrodziło się dzięki opiniom i pytaniom naszych klientów, skontaktuj się więc z nami, abyśmy mogli pomóc Tobie, a Ty w ten sposób pomożesz innym! Pomoc Techniczna firmy Arlon jest po to, aby Tobie służyć.

Skontaktuj się z Działem Obsługi Klienta