Series 3510 Slip-Resistant

Monomeric Overlaminate For Floors

Series 3510 is a 80 microns monomeric film with a clear, permanent pressure-sensitive adhesive. Designed to protect your printed image, Series 3510 is made of a monomeric facestock and available in a gloss or matte finish. 
Series 3510 is rated for outdoor durability of 3 years.

Applications & Features

  • Series 3510 Matte is approved under the European Standard Certification EN 14041 for slip-resistance for interior floor graphics
  • Protective overlaminate for indoor floor graphics
  • Ideal for interior applications on flat surfaces
  • Arlon overlaminate film is designed to be laminated cold without any heat

Performance & Physical Data

Property Test Methods Typical Value
Surface Finish Gloss Meter 60° Reflection Matte: 1.5 to 10 Gloss Units
Thickness Micrometer, Federal Bench Type 80 microns
Tensile Strength Tensile Tester with 51 mm jaw separation; crosshead speed of 5.1 mm/s, web direction ≥ 2.68 kg/cm
Elongation Instron Tensile Tester as above ≥ 250%
Shelf Life (In Box) Ideal Storage Temperature 21°C and 50% relative humidity 1 year from factory shipment
Application Temperature Range On clean, dry substrate 10°C to 32°C
Service Temperature Range Film applied to etched aluminum panels 24 hours prior to testing -29°C to 65°C
Dimensional Stability 70°C, 48 hours, on aluminum panel 0.13 mm
Peel Adhesion PSTC-1, 15 min, 21°C ≥ 0.27 kg/cm
Peel Adhesion PSTC-1, 24 hrs, 21°C 10.7N 25/mm
Liner Release TLMI Release at 90°, 760 cm/min 24.6 g/cm
Note: Stiffness of monomeric/polymeric films may not conform as well to surface topography of UV inks. Standard Terms & Conditions Apply

FLOOR APPLICATION

Series 3510 Matte is approved under the European Standard Certification EN 14041 regulating for slip-resistance as a floor graphic material for indoor dry conditions. Arlon recommends DPF 510 UT / GTR / MTR / GT / MT as the compatible media. These product combinations are recommended for short term interior floor applications, for an expected life of up to 3 months. To determine the best product for the application Arlon always recommends testing on the surface before using the above products. Product performance can vary greatly depending on the surface type, level of foot traffic, elemental exposure and floor condition. Due to these variables, Arlon is unable to offer a warranty for the performance, expected life, or clean removability of these products for floor graphic applications.

See Arlon’s Standard Limited Warranty, which is available at https://www.arlon.com/eu_en/support/warranties  

Please refer to Arlon’s Installation Guide for detailed techniques and best practices.

EN 14041 - Resilient, textile and laminate floor coverings
Determination of the anti-slip properties (EN 14041): Determination of the dynamic coefficient of friction of floor materials in accordance with EN 14041.

TERMS & CONDITIONS

The following is made in lieu of all warranties expressed or implied:

All orders and purchases made in connection with this document are governed and limited by Arlon’s Standard Terms and Conditions, which are incorporated in full by this reference and are available at https://www.arlon.com/eu_en/legal/terms-and-conditions or in hardcopy by request.

Copyright © Arlon Graphics, LLC. All Rights Reserved.